Ford AG1Z-18124-C Shock Absorber Assembly

You can Select Your Vehicle to check if AG1Z-18124-C fits your vehicle.

If the vehicle's body continues to move excessively after being pushed down, worn or weak shock absorbers may be the cause.

Ensure the steering is unlocked. Loosen the strut upper mounting nuts but do not remove them. Loosen the wheel lug nuts, raise the vehicle and support it securely on jackstands, then remove the wheel. Have an assistant depress the brake pedal, then remove the driveaxle/hub nut. Remove the brake disc, separate the tie-rod end from the steering knuckle, and detach the stabilizer bar link from the strut. Detach the wheel speed sensor harness from the strut, remove the bolt, and pull the wheel speed sensor from the steering knuckle. Separate the control arm balljoint from the steering knuckle. Using a front wheel hub remover, press the driveaxle from the hub splines. Remove the upper mounting nuts and remove the strut and steering knuckle as an assembly.

For 2013 and later models, start by loosening the wheel lug nuts, raising the vehicle, and supporting it securely on jackstands, blocking the front wheels. Remove the rear wheel and open the trunk to pull back the interior quarter trim panel. Detach the stabilizer bar link from the rear knuckle and support the lower suspension arm with a floor jack placed under the spring pocket. Remove the shock absorber upper mounting nut and the shock absorber lower mounting bolt to take out the shock absorber.

Inspect the shock body for leaking fluid, dents, cracks, and other damage which would warrant replacement. Check the coil spring for chips or cracks in the spring coating and the spring seat for cuts, hardness, and general deterioration. If any undesirable conditions exist, proceed to the shock absorber/coil spring disassembly procedure.