Ford GU2Z-18A092-AJ Strut - Loaded Assembly

You can Select Your Vehicle to check if GU2Z-18A092-AJ fits your vehicle.

Check the shock absorbers to ensure they are securely mounted and undamaged. Inspect the upper mounts for damage and wear. If damage or wear is observed, replace the shock absorbers as a set (front or rear).

Locate the upper retaining nut on top of the frame, and if necessary, hold the piston rod with a wrench or locking pliers while loosening the nut. Remove the upper nut, washer, and insulator from the stud on the upper side of the frame.

Removal starts by removing the shock absorber upper attaching nut, washer, and bushing to detach the upper end of the shock absorber. For upper balljoint replacement on 1992 and later models, it's crucial to mark the location of the alignment marks on the adjustment cams before removing the two retaining nuts.

Ensure that all air is expelled from the new shock absorber by extending and compressing it several times before placing the inner washer and rubber insulator on the shock piston rod. Insert the rod through the upper mounting hole in the frame, attach the outer insulator, washer, and a new stud retaining nut on the upper side of the frame, making sure the insulator "pilots" engage properly in the frame attaching holes. Tighten the nut to the specified torque.

Inspect the shock absorber for leaking fluid, dents, cracks, and other damage. Examine the coil spring for chips and cracks that could lead to premature failure. Also, inspect the spring seats for hardness and general deterioration.

If any free play is noted, check the steering gear mounts and the tie-rod ends for looseness. Verify the steering gear mount bolt tightness. If the tie-rods are loose, the ball joints may be worn.