Lincoln E2FZ-12127-H Distributor Assembly

You can Select Your Vehicle to check if E2FZ-12127-H fits your vehicle.

To remove the distributor, start by unplugging the primary electrical connector. Note the raised "1" on the distributor cap, which marks the terminal for the number 1 spark plug wire. Remove the distributor cap and, if you have a remote starter, follow the manufacturer's instructions to turn the engine over until the rotor is pointing towards the number 1 cylinder. If you don't have a remote starter, rotate the crankshaft until the rotor is pointing towards the number 1 plug wire terminal. Make a mark on the distributor base directly below the rotor tip and in line with it, as well as on the distributor base and the engine block for proper reinstallation. Remove the distributor hold down-bolt and clamp, then pull the distributor straight up to remove it. To install the distributor, insert it into the engine in the same relationship to the block as before. Check the alignment marks and rotor position, then turn the crankshaft in the normal direction of rotation to engage the gears. Seat the distributor against the block and align the marks made on the distributor base and the block. Install the hold-down clamp, distributor cap, and module electrical connector. Reattach the spark plug wires and connect the battery cable. Finally, check the ignition timing and tighten the distributor hold-down bolt securely.

Start by unplugging the primary lead from the coil and the electrical connector for the module. Then, remove the distributor cap.

Check the ignition timing and tighten the distributor hold-down bolt securely.

After installing the distributor, you should check and adjust the ignition timing if necessary, and tighten the distributor hold-down bolt securely.

To install the distributor, insert it into the engine in the same position as before. Check the alignment marks and rotor to ensure proper placement. Install the hold-down clamp and bolt, tighten the distributor cap, and plug in the module electrical connector. Reattach the spark plug wires and connect the battery.

Start by unplugging the primary lead from the coil and the electrical connector for the module. Then, remove the distributor cap and turn the engine until the rotor is pointing towards the number one spark plug terminal. Make marks on the distributor base and engine block to ensure proper installation. Remove the distributor hold-down bolt and clamp, and carefully pull the distributor straight up.

Do not turn the engine, or the alignment marks will be useless.