Lincoln E9TZ-7B066-A Drive Plate - Clutch

You can Select Your Vehicle to check if E9TZ-7B066-A fits your vehicle.

Install the clutch housing and ensure to reinstall any shims between the block and housing. Tighten the bolts to the torque specification.

Reinstall the transmission and all previously removed components. Lower the vehicle, reactivate the air suspension system if applicable, and you're done with the installation.

By removing the transmission (and transfer case on 4WD models), leaving the engine in the vehicle.

Reassemble by positioning the pressure plate on the flywheel and aligning the clutch disc with the flywheel using an alignment tool. Tighten the pressure plate-to-flywheel bolts evenly in a criss-cross pattern, centering the clutch disc with the alignment tool. Lubricate the release bearing and install it, along with the clutch release cylinder if removed earlier.

1. Remove the flywheel. 2. Position the pressure plate on the flywheel and place both in a hydraulic press. 3. Depress the clutch diaphragm fingers until the adjusting ring moves freely. 4. Move the adjusting ring counterclockwise with a screwdriver until the tension springs are compressed. 5. Release pressure on the diaphragm fingers while holding the adjusting ring in place. 6. Remove the flywheel and pressure plate from the press.