Lincoln 1W1Z-13008-AC Headlamp Assembly

You can Select Your Vehicle to check if 1W1Z-13008-AC fits your vehicle.

Disconnect the cable from the negative battery terminal for models through 1997. Remove the headlight bulb(s). Push forward on the headlight housing while using snap-ring pliers to spread the retainer clips, then detach the housing and remove it through the grille opening. Use snap-ring pliers to spread the clips, then detach the headlight housing. Insert the housing into the grille opening and press it into place until it seats securely in the retainers. For 1998 and later models, remove the plastic sight shield over the radiator. Pull up the three white plastic pins mounted vertically above each headlight housing. Pull the housing forward and disconnect the electrical connectors. Installation is the reverse of the removal procedure.

If the headlights cannot be adjusted adequately using the described method or if a compromise has to be made, it is advisable to have the headlights adjusted by a dealer service department or service station at the earliest opportunity.

To install the headlight, connect the electrical connector, place the headlight in position and install the retainer and screws. Tighten the screws securely. Finally, place the bezel in position and install the retaining screws.