Lincoln F5VY-13008-A Headlamp Assembly

You can Select Your Vehicle to check if F5VY-13008-A fits your vehicle.

Disconnect cable from negative battery terminal. Remove retaining screws and detach headlight bezel. Carefully remove headlight retainer screws, avoiding adjusting screws. Use Phillips head screwdriver. Remove retainer and pull headlight out enough to disconnect electrical connector. Remove headlight and connector. To install, connect electrical connector, place headlight in position, and install retainer and screws. Place bezel and install retaining screws.Composite bulb-type: Warning: Halogen bulbs are under pressure and may shatter if scratched or dropped. Wear eye protection and handle bulbs carefully, grasping only the base. Avoid touching bulb surface with fingers to prevent overheating. Clean surface with rubbing alcohol if touched. Open hood. Twist plastic retainers and remove sight shield for access to headlight housings. Disconnect cable from negative battery terminal. Remove cover and reach behind headlight assembly. Turn bulb holder counterclockwise to remove. Lift holder assembly for bulb access. On newer models, remove headlight housing for bulb holder access. Release clip and disconnect bulb holder from connector. Insert new bulb into connector until it snaps into place. Install bulb holder in headlight assembly.

Pull up the three white plastic pins mounted vertically above each headlight housing and pull the housing forward while disconnecting the electrical connectors.

Headlights have two spring-loaded adjusting screws: one on the top for controlling up-and-down movement and one on the side for controlling left-and-right movement.