Lincoln 4L3Z-11582-BB Lockset - Complete Vehicle

You can Select Your Vehicle to check if 4L3Z-11582-BB fits your vehicle.

To remove the ignition lock cylinder it is required that the negative cable be disconnected from the battery followed by disconnecting the positive cable and waiting for 2 minutes. Second, switch the key to the Run position. Use a 1/8 inch punch to push down on the hole located at the bottom of the steering column cover that is surrounding the lock cylinder at the same time pulling on the lock refer to it as cylinder to be able to remove it from the housing of the steering column. For installation, push in the retaining pin located on the side of the lock cylinder and turn the ignition key to the 'Run' position. Place the lock cylinder back into the steering column housing so as to fit into the hole provided and slide in until it locates the interlocking washer appropriately. Twist the key anticlockwise to unlock the retaining pin so that it goes back to it slot at the steering column housing. Last of all, rotate the lock to ensure that the operation is correct in all positions and finally fix the lock in place by reversing all the operations that were followed to remove the lock.

To remove the ignition lock cylinder it is required that the negative cable be disconnected from the battery followed by disconnecting the positive cable and waiting for 2 minutes. Second, switch the key to the Run position. Use a 1/8 inch punch to push down on the hole located at the bottom of the steering column cover that is surrounding the lock cylinder at the same time pulling on the lock refer to it as cylinder to be able to remove it from the housing of the steering column. For installation, push in the retaining pin located on the side of the lock cylinder and turn the ignition key to the 'Run' position. Place the lock cylinder back into the steering column housing so as to fit into the hole provided and slide in until it locates the interlocking washer appropriately. Twist the key anticlockwise to unlock the retaining pin so that it goes back to it slot at the steering column housing. Last of all, rotate the lock to ensure that the operation is correct in all positions and finally fix the lock in place by reversing all the operations that were followed to remove the lock.

1. Disconnect the electrical connector from the ignition switch. 2. To detach the ignition switch from the steering column, depress the release tabs on the top and bottom of the switch, then pull the switch out. 3. Installation is the reverse of removal.

NO, TUMBLER HAS TO BE BUILT AROUND EXISTING KEY