Lincoln F8AZ-4234-CA Shaft

You can Select Your Vehicle to check if F8AZ-4234-CA fits your vehicle.

To remove the rear axle assembly, disconnect the battery cable, loosen lug nuts, raise the vehicle, remove wheels, brake components, and axle cover. Disconnect ABS sensors, axleshafts, brake lines, and backing plates. Unbolt driveshaft, raise axle, disconnect safety chain or air springs, remove shock absorbers and suspension arm bolts. Disconnect axle-locating arms, Watts-linkage assembly, and height sensor if applicable. Lower axle housing, remove coil springs or air springs. Lower suspension arm bolts, remove axle housing. For installation, raise axle, secure with suspension arm bolts, install springs, connect lower suspension arms. Raise axle to normal height, tighten suspension arm bolts, reattach height sensor if applicable. Connect shock absorbers, driveshaft, and backing plates. Reconnect sensor wires, brake lines, and parking brake cables. Install axleshafts, brake components, axle cover, and fill differential. Install wheels, lower vehicle, and tighten lug nuts.

Remove both rear axleshafts and free the ABS sensor wires, parking brake cables, and brake lines from their clips.

Remove the cover from the differential carrier and allow the lubricant to drain into a container.

Begin by loosening the wheel lug nuts, then raise the rear of the vehicle and securely support it on jackstands. Remove the wheel and, if applicable, the brake drum or the caliper and disc.

Begin by loosening the wheel lug nuts, then raise the rear of the vehicle and securely support it on jackstands. Remove the wheel and, if applicable, the brake drum or the caliper and disc.

Start by disconnecting the negative battery cable, loosening the rear wheel lug nuts, and raising the rear of the vehicle using jackstands under the frame. Proceed to remove the rear wheels.