Lincoln DG9Z-11572-A Switch Assembly - Ignition

You can Select Your Vehicle to check if DG9Z-11572-A fits your vehicle.

Disconnect the negative cable from the battery and turn the Ignition Lock Cylinder to ON for 2006 and earlier model years. Push a 1/8-inch awl or punch through designated holes in the steering column cover and housing to depress the lock cylinder release button while pulling it out. During the installation of the Ignition Lock Cylinder, make sure the Ignition Lock Cylinder is on, align ridges on the cylinder with grooves inside the receptacle and turn the Ignition Lock Cylinder back to OFF so that the release button can be returned to its place. Verify proper operation, reconnect battery first, then perform PCM relearning process if necessary. Remove the steering column covers after disconnecting the negative battery cable on 2007 models or later ones. Use a sharp-tipped pick to release the anti-theft module's locking tabs; remove it from the Ignition Lock Cylinder assembly by this means. Insert key into ACC position turning it clockwise until resistance is felt; insert thin rod into access hole through which release pin passes while pulling outwards on key shafts.

To remove the ignition switch, disengage it from the lock cylinder housing by depressing the two release tabs.

Disconnect the cable from the negative terminal of the battery.

Installation is the reverse of removal.

Remove the center console trim panel.

Insert an awl or suitable tool into the hole in the underside of the key lock cylinder, then depress the key lock cylinder retaining tab and remove the key lock cylinder.

Disconnect the cable from the negative terminal of the battery.