Mercury D8BZ-13466-A Bulb

You can Select Your Vehicle to check if D8BZ-13466-A fits your vehicle.

The clutch trim panel needs to be removed.

1. Remove the two high-mount brake light retaining screws, pull out the center high-mount brake light assembly, and lay it upside down on the roof. 2. Remove the socket with the burned-out bulb from the center high-mount brake light assembly by turning it counterclockwise and pulling it out. 3. Remove the old bulb from the socket by pulling it straight out. 4. To install a new bulb in the socket, insert it straight into the socket until it stops. 5. Installation is the reverse of removal.

Carefully pull the bulb straight out of the socket.

Carefully pull the bulb straight out of the socket without rotating it.

Lift the holder assembly out for access to the bulb.

Grasp the bulb holder and turn it counterclockwise to remove it.

Disconnect the battery negative cable.

Carefully pull the bulb straight out of the socket. Do not rotate the bulb during removal.

Have the headlight adjustment checked and, if necessary, adjusted by a dealer service department or service station at the earliest opportunity.

Rotate the headlight bulb retaining ring counterclockwise and pull out the bulb socket. To remove the headlight bulb from the headlight housing, turn it counterclockwise and pull it out. On 2011 and later models, remove the headlight bulb by twisting it a small amount counterclockwise. Remove the park/turn bulb and the side marker light in the same manner.