Mercury F1VY-2V130-ARM Caliper With Pads

You can Select Your Vehicle to check if F1VY-2V130-ARM fits your vehicle.

To overhaul the rear calipers for 1975 through 1990 Continental and Mark series and 1981 through 1988 Town Car, start by raising the vehicle and supporting it securely on jackstands. Remove the rear wheels and disconnect the parking brake cable at the lever. Disconnect the brake hose and plug the end. Remove the calipers, and if necessary, loosen the caliper and retainer to force the piston back into its bore. Clean and inspect the caliper, anchor plate, and disc for corrosion, wear, and fluid leakage. Reinstall the brake pads and caliper, adjusting the piston as needed. Connect and adjust the parking brake cable, install the wheels, and take the vehicle for a test drive to check for proper braking action.

Lubricate the piston, push it into the caliper by hand, and use a C-clamp and wood block to seat it properly.

To overhaul the front calipers and 1989 and later Town Car rear calipers, start by raising the vehicle, supporting it on jackstands, and removing the wheels. Disconnect the brake hose banjo bolt and detach the hose from the caliper, ensuring no air enters the hydraulic control unit on ABS-equipped models. Clean the caliper exterior with brake system cleaner and place it on a clean workbench. Use compressed air with caution to remove the piston from the caliper and proceed to remove the dust boot and piston seal. Inspect the piston and caliper bore for damage, corrosion, or wear. Clean all parts with brake system cleaner and reassemble with new seals, bolt insulators, and caliper bolts if necessary. Lubricate with brake fluid and install the piston, dust boot, and caliper bolt insulators. Finally, follow the caliper installation procedure, connect the brake hose, bleed the brakes, and test the brake operation before placing the vehicle into normal service.

Unscrew the brake hose banjo bolt and detach the hose from the caliper, replacing the sealing washers with new ones. If the caliper won't be entirely removed, leave the hose connected and suspend the caliper with wire to avoid the need for brake system bleeding.