Mercury E7TZ-11654-B Switch Assembly

You can Select Your Vehicle to check if E7TZ-11654-B fits your vehicle.

Disconnect the negative battery cable from the battery. For 1993 and 1994 models, remove the ashtray and two instrument panel trim panel screws, then snap off the trim panel and the storage bin. Pull the headlight switch out as far as it will go, then reach up along the side of the switch nearest the driver's door to push the knob release button. While holding the button down, pull the knob and shaft out of the switch. Unscrew the switch retaining nut with your fingers, being cautious as the nut is plastic and should not be handled with tools. Disconnect the electrical connector from the switch and take the switch out. For installation, follow the reverse order of removal, ensuring the switch tab aligns with the notch in the instrument panel. For 1995 and later models, remove the instrument cluster bezel, then remove the switch screws and detach the switch from the bezel, noting that later models use retaining tabs instead of screws. To remove the switch, depress the tabs and pull it out, and for installation, follow the reverse order of removal.

It is necessary to pull the knob to release the headlight. You need to disconnect the ground cable of the battery. Pulling the knob to the position of the headlight. The shaft release button should be depressed and then, remove the assembly consisting of knob and shaft. Remove the finished panel from the instrument panel. When you unscrew the mounting nut, you can take off the switch, but don't forget about wiring the connector first. Plug in a plug from a wire into an instrument board switch for headlights, install it in an instrument board, and turn a nut on. Don't forget to hang the installed panel assembly on an instrument panel again. Push the shaft into switches with headlamp knobs until they catch. Connect your battery earth and check your light switch.

Reach under the dash and press the shaft lock tab while pulling the knob and shaft away from the cluster panel.

Pull the headlamp switch to the On position.

Disconnect the electrical connector, remove the two screws, and remove the switch.

Unscrew the switch molding nut and pull the switch out through the rear of the dash.