What is the general information about relays on Ford Crown Victoria?

In the fuel injection system of the vehicle and horns, the starter, the fog lamps, and many other electrical appliances in the car, relays are used to transference electrical stimuli to the appliance. Relays control a low current control circuit to switch on or off a high current power circuit, and therefore an unreliable relay will cause the relevant component not to work as required. Main and additional relays are located in the engine compartment, together with other electrical equipment; the underhood power center is situated near the battery and includes relays and high amperage fuses. Some cars of the late model use a relay box near the brake master cylinder along with relays for air conditioner WOT cutout, fuel pump, PCM power, and PCM power diode. In a case of suspected faulty relay it can be unbolted and checked, there is onboard procedure or check by the local service provider. In case of relays with short or open circuits, these must be replaced as a complete assembly. For proper hook-ups while testing a relay, one needs to look at wiring diagrams; where these are not available, a set of details noted follows in the information list. Typically relays come in type with two terminals for the control circuit which is connected to the relay coil, and the rest of the terminals for the power circuit which closes internally when the coil is energized. They are normally labelled so that control and power circuits can easily be distinguished from one another. To test, click the relay and ground the terminal on the other side of the circuit in the case there will be no continuity between terminal 30 and 87. Then add a fused jumper wire from one of the control circuit terminals to the positive battery terminal and another wire from the second control circuit terminal to ground; the relay should click. If it does not, try flipping the jumper wires. When the jumper wires are connecting, you should ground continuity between the power circuit terminals, and the continuity reading should be now between 30 and 87 terminals. If the relay does not pass any of these tests it is recommended that it should be replaced.

Genuine Ford Crown Victoria Relay

Wire Relay

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

18 Relays found

View related parts
Ford Crown Victoria Relay
Part Number: FOAZ-14N089-A
$16.62 MSRP: $25.00
You Save: $8.38 (34%)
ADD TO CART
Product Specifications
- Replaced by: 5M5Z-14N089-A
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992-2011 Ford Crown Victoria | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4AT, 4AT 4R70W, 4AT 4R75W, 4AT AOD, 4AT AOD-E, 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Relay
Part Number: F8OZ-14N089-AA
$24.10 MSRP: $34.33
You Save: $10.23 (30%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998-2011 Ford Crown Victoria | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4AT, 4AT 4R70W, 4AT 4R75W, 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Direction Indicator Relay
Part Number: 5C3Z-13350-AA
$26.11 MSRP: $41.64
You Save: $15.53 (38%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Relay - Direction Indicator
- Replaces: F65Z-13350-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2011 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Relay
Part Number: 6W1Z-8B658-AC
$144.10 MSRP: $238.18
You Save: $94.08 (40%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Fan Relay
- Replaces: 6W1Z-8B658-AB
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2011 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Direction Indicator Relay
Part Number: 5L5Z-13350-AA
$30.21 MSRP: $48.18
You Save: $17.97 (38%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Relay - Direction Indicator; Flasher, Flasher Relay, Relay, Turn Signal Flasher
- Replaces: F67Z-13350-AA, F67Z-13350-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2011 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Relay
Part Number: 9L2Z-14N089-A
$19.95 MSRP: $29.17
You Save: $9.22 (32%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Replaced by: 5M5Z-14N089-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2011 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Relay
Part Number: FOAZ-14N089-B
$54.63 MSRP: $99.50
You Save: $44.87 (46%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Replaced by: AU5Z-14N089-FA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992-2011 Ford Crown Victoria | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4AT, 4AT 4R70W, 4AT 4R75W, 4AT AOD, 4AT AOD-E, 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Relay
Part Number: F5TZ-14N089-B
$9.57 MSRP: $13.63
You Save: $4.06 (30%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Horn Relay, Sentinel Relay, Wiper Relay
- Replaced by: 5M5Z-14N089-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2003-2011 Ford Crown Victoria | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4AT, 4AT 4R70W, 4AT 4R75W, 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Relay
Part Number: 5C3Z-14N089-A
$16.38 MSRP: $23.33
You Save: $6.95 (30%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Replaced by: 5M5Z-14N089-CA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2011 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Direction Indicator Relay
Part Number: 3W7Z-13350-AB
$57.65 MSRP: $114.55
You Save: $56.90 (50%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Relay - Direction Indicator
- Manufacturer Note: WIG WAG Relay
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2011 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Relay
Part Number: F8AZ-13C718-AA
$0.00
Product Specifications
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998-2006 Ford Crown Victoria | 8 Cyl 4.6L | 4AT, 4AT 4R70W, 4AT 4R75W
View related parts
Ford Crown Victoria Direction Indicator Relay
Part Number: 1W7Z-13350-AA
Product Specifications
- Other Name: Relay - Direction Indicator
- Manufacturer Note: Flasher assembly for police lamps, Police
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2001-2002 Ford Crown Victoria | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Ford Crown Victoria Direction Indicator Relay
Part Number: 3W7Z-13350-AA
Product Specifications
- Other Name: Relay - Direction Indicator
- Manufacturer Note: Flasher assembly for police lamps - "wig wag module", Police
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2003-2005 Ford Crown Victoria | 8 Cyl 4.6L | 4AT, 4AT 4R70W, 4AT 4R75W
View related parts
Ford Crown Victoria Direction Indicator Relay
Part Number: 6W7Z-13350-A
Product Specifications
- Other Name: Relay - Direction Indicator
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2006-2011 Ford Crown Victoria | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4AT, 4AT 4R75W, 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Crown Victoria Relay
Part Number: E3FZ-9345-B
Product Specifications
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992-1995 Ford Crown Victoria | 8 Cyl 4.6L | 4AT AOD, 4AT AOD-E
View related parts
Ford Crown Victoria Relay
Part Number: E3FZ-9345-D
Product Specifications
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992-1993 Ford Crown Victoria | 8 Cyl 4.6L | 4AT AOD, 4AT AOD-E
View related parts
Ford Crown Victoria Relay
Part Number: F19Z-9345-A
Product Specifications
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992-1993 Ford Crown Victoria | 8 Cyl 4.6L | 4AT AOD, 4AT AOD-E
View related parts
Ford Crown Victoria Relay
Part Number: F1SZ-9345-A
Product Specifications
- Other Name: Fuel Pump Relay
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1992-2006 Ford Crown Victoria | 8 Cyl 4.6L | 4AT, 4AT 4R70W, 4AT 4R75W, 4AT AOD, 4AT AOD-E

Ford Crown Victoria Relay

We provide a wide range of Ford Crown Victoria Relay at the best prices possible. If you need Ford Crown Victoria Relay, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.

Ford Crown Victoria Relay Parts Questions & Experts Answers

Relay
F1SZ-9345-A
Q: What is the general information about relays on Ford Crown Victoria?
A: In the fuel injection system of the vehicle and horns, the starter, the fog lamps, and many other electrical appliances in the car, relays are used to transference electrical stimuli to the appliance. Relays control a low current control circuit to switch on or off a high current power circuit, and therefore an unreliable relay will cause the relevant component not to work as required. Main and additional relays are located in the engine compartment, together with other electrical equipment; the underhood power center is situated near the battery and includes relays and high amperage fuses. Some cars of the late model use a relay box near the brake master cylinder along with relays for air conditioner WOT cutout, fuel pump, PCM power, and PCM power diode. In a case of suspected faulty relay it can be unbolted and checked, there is onboard procedure or check by the local service provider. In case of relays with short or open circuits, these must be replaced as a complete assembly. For proper hook-ups while testing a relay, one needs to look at wiring diagrams; where these are not available, a set of details noted follows in the information list. Typically relays come in type with two terminals for the control circuit which is connected to the relay coil, and the rest of the terminals for the power circuit which closes internally when the coil is energized. They are normally labelled so that control and power circuits can easily be distinguished from one another. To test, click the relay and ground the terminal on the other side of the circuit in the case there will be no continuity between terminal 30 and 87. Then add a fused jumper wire from one of the control circuit terminals to the positive battery terminal and another wire from the second control circuit terminal to ground; the relay should click. If it does not, try flipping the jumper wires. When the jumper wires are connecting, you should ground continuity between the power circuit terminals, and the continuity reading should be now between 30 and 87 terminals. If the relay does not pass any of these tests it is recommended that it should be replaced.