Q: How to remove and install the steering gear on Ford Edge?
A: To remove the rack and pinion, disconnect the battery cable, loosen lug nuts, raise the vehicle, remove front wheels, separate tie-rod ends, disconnect power steering lines, remove stabilizer bar, unhook steering shaft, take off heat shield and pressure line retainers and drop rack and pinion from the subframe. To return the device to its position; use new fasteners, rack and pinion turn tube heat wrap, and sealing washers. While hooking up the column shaft of a steering system align match marks, tighten banjo bolt, fill the power steering reservoir, bleed hydraulic system, and check front-end alignment.