Ford 7W7Z-18125-D Shock Absorber Assembly

You can Select Your Vehicle to check if 7W7Z-18125-D fits your vehicle.

If the vehicle has an air suspension, turn the air suspension switch to On, start the engine, and let the compressor inflate the air suspension springs before driving.

During installation, ensure all air is expelled from a new shock absorber (for 2002 and earlier models), install all bushings and grommets in the order of removal, and use 5116-18 locknuts on the self-tapping bolts if the threads in the lower control arm are stripped or damaged. Tighten all fasteners to the specified torque, with locknuts torqued to the same specification as the bolts.

Check the shock absorbers to ensure they are securely mounted and undamaged. Inspect the upper mounts for damage and wear. If damage or wear is observed, replace the shock absorbers as a set (front or rear).

Removal starts by removing the shock absorber upper attaching nut, washer, and bushing to detach the upper end of the shock absorber. For upper balljoint replacement on 1992 and later models, it's crucial to mark the location of the alignment marks on the adjustment cams before removing the two retaining nuts.

Extend the shock absorber, insert the lower shock stud through the hole in the bracket on the axle tube, install a new self-locking retaining nut, and tighten it to the specified torque.

Park the vehicle on level ground, turn off the engine, and set the parking brake. Check tire pressures. Push down at one corner of the vehicle, then release it while noting the movement of the body. It should stop moving and come to rest in a level position within one or two bounces.